Introduction

HNR to ZERO Telemetry Service enables customer integration to measurement services including the TP-Link Tapo Cloud platform**.**

Grafana dashboards can be provided as part of this service to enable near-realtime visualisation of measurements of devices connected to the integrated measurement service.

HNR to ZERO additionally aggregates data on an hourly basis to provide historical aggregated data within the platform.

Telemetry Service is configurable on a per integration basis allowing for both integration and device level configuration.

Telemetry Management can be found under Settings.

Screenshot 2024-10-01 at 08.59.27.png

Telemetry Configuration Management

Selecting Edit within the Configuration Overview section allows for full Telemetry Service level configuration details to be managed including, but not limited to,

<aside> 💡

Be aware that decreasing the sampling interval will increase the volume of measurement calls and this will, as a result, increase the cost of measurement.

Setting the sampling interval to small increments (e.g. 10 seconds) is experimental and could result in loss of samples due to the integrated measurement service restricting the volume of calls (i.e. rate limiting).

</aside>

Device Management

The Device List contains a list of all devices the platform identifies as connected to the integration specified in the specific telemetry configuration.